Generally refers to the AB glue is epoxy glue, glue is toxic. Non-toxic non-plastic! However, the correct use does not affect the body, as long as more than 24 hours on it. And after curing no mention of any toxicity, you can use it to do food processing container preservatives, such as soy sauce Vinegar pool wall treatment.
　　AB plastic use of the Notes:
　　1, studios and appliances must be kept clean, otherwise it will affect the glue quality and bonding effect, especially the oil, dust will affect the transparency and adhesion of Epoxy. Indoor humidity should not be too large, try to keep the ventilation or exhaust fan, walking as far as possible to wear slippers or shoe covers, indoor air is too turbid, sprinkle a small amount of water droplets on the ground.
　　2, Drip workshop as far as possible to maintain room temperature 25 degrees, the temperature of the glue can be used time and curing time has a great impact, the other air conditioning, pay attention to the outlet water spray directly on the surface of the adhesive, and B chemical composition , From white fog, oil, particles and other phenomena.
　　3, Dijiao workstations as smooth as possible in order to avoid the flow of plastic, plastic, drops are not in place, drops uneven conditions, you can use the balance of equipment, balance feet to the first test.
　　4, the temperature of the greater impact on the curing of the product, the temperature increases the curing time to accelerate, as the temperature decreases the curing time, the temperature can not be used, will damage the nature of the glue, can not be restored to its original. Cured products can not be for a long time under the conditions of intense baking temperature, the general can not be higher than 110 degrees, anti-aging test experiment, on the conditions of about 65 degrees bake for a few hours, you can observe.
　　5, the glue must be sealed and kept in a cool and ventilated place, to avoid heat or sunlight, a large part of the yellow is due to the glue is not resistant to UV ultraviolet light in the sun, or beyond a certain period of exposure to light.
　　he curing of the glue to the hard side, or even can not be dried; such as the B component is too small, the curing speed slowed the glue soft, or even can not dry .
　　7, such glue chemical general shelf life of 6-8 months, if found within the shelf life of any one component precipitation, please re-use the new mix or contact us to replace.
　　8, Drip products, if the drop edge after the phenomenon, the first with acetone or toluene rub the surface dirt and oil, or the first injection and then glue, such glue (containing PU) is composed of oily materials, plus color cream Mixing powder, to fuel the composition of materials, or there will be stratification.
　　9, Drip ratio, stirring moderate should not be too fast too fast, along the wall slowly with a uniform, fully mixed to make the chemical reaction more fully, better mobility, but also conducive to better defoaming.
　　10, pour out the unused glue, prohibited the original vat pack back into the original, the impurity component will make the whole barrel scrapped. Each open glue AB to 200g best, too much reaction will focus more energy, can be used for a shorter time, poor liquidity.